0

Your Cart

0
Subtotal: AUD0
No products in the cart.

Power Systems Technical Articles

Our experts continuously work on power systems problems, and we share solutions with Practical Reference Articles.

The main topics are earthing system modeling, power cable ratings, HV/LV electrical design, protective device coordination, and arc flash studies. We cover IEC and IEEE standards.

Sign up for my email newsletter and I will send you the latest technical articles as they are released – Jayson Patrick.

Photo of Jayson Patrick for Technical Articles page about electrical power systems Design

Choose the article category

3 mins read
Should a metal fence be bonded to the substation earth grid? The metal fences around substations keep people out but they pose earthing safety challenges. These metallic fences, which are easily accessible to the public and personnel, must be adequately earthed and touch voltages on them during an electrical fault must not exceed safe limits.
2 mins read
How to model the influence of an additional substances like bentonite surrounding the conductors of a buried earthing system on grid resistance, touch and step voltages.
1 min read
During an earth fault on a substation earth grid, the flow of current to the earth will produce voltage gradients. An earth grid that is properly designed will safely dissipate current into the ground.
Accurately calculating voltage drop results in lower voltage drops which leads to smaller cable sizes and saves money.
5 mins read
The methods for calculating the current rating of multiple cables installed in ventilated tunnels are explained with example calculations. Overall tunnel length and air velocity inside the tunnel have a significant impact on cable current ratings.
4 mins read
Learn about thermal analysis for HVDC submarine cables, focusing on the 2 K Criterion to minimize environmental impacts.
This report shows the effects of a direct lightning strike to an air terminal installed on top of a building which is connected to a buried earthing system.
This article explains why dynamic ratings are important when dealing with long AC cables for wind farms. An example calculation of a dynamic rating which uses the measured load profile is given.
7 mins read
Crossing multiple cables or heat sources at a crossing angle causes a current rating reduction, calculated using IEC Standard 60287.
Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors